Programming
PROGRAMME
PROG 2/OFFSET (e.g. shutters are lowered to ventilation
position in the evening)
O K
O K
O K
PROGRAMME
PROG 2
OFFSET
OFFSET
min
▼
PROGRAMM
OK
OK
OK
OK
+/–
1. Press the MENU button.
2. To select the PROGAMME menu, press the
+ button until PROGAMME appears.
3. Confirm by pressing OK.
4. Press the + button until PROG 2 appears.
5. Confirm by pressing OK.
6. Press the + button until the OFFSET menu appears.
7. Confirm by pressing OK.
8. You can set the time for the down control command to be
triggered separately using the +/- button (max. +/- 240 mins,
depending on PROG 1 SWITCHING TIME
▼
).
Confirm your entry by pressing OK.
9. Press the MENU button to switch to operating mode.
Note: Using the SETTING menu level, you must enter the swit-
ching time of the intermediate position and select PROG 2
VENTILATION for the position of the end limits.
Warnhinweise
Programming
SETTING
HOLIDAY, LIGHT SENSOR (Holiday OFF/ON, sun/twilight setting)
SETTING
HOLIDAY
HOLIDAY ON
LIGHT
SENSOR
CONNECTED ?
SUN
TWILIGHT
OK
OK
OK
+/–
+/–
+/–
OK
see
next page
1. Press the MENU button.
2. To select the SETTING menu, press the
+ button until SETTING appears.
3. Confirm by pressing OK. HOLIDAY ON/OFF will appear.
4. You can set the holiday function to ON or OFF by pressing the
+/- button.
5. Confirm your selection by pressing OK.
N.B.: This dialog window will only be displayed if a light sensor is
connected to the device.
You have confirmed the holiday function. SUN will appear.
The value set is displayed.
6. You can reset the sunlight setting by pressing the +/- button.
(The two digits on the left of the display show the current light
value)
7. Confirm your entry by pressing OK.
To set the TWILIGHT SETTING, follow the same procedure as for
SUN.
The SUN/TWILIGHT function has now been set.
Please read on for further programming options using the
SETTING menu.
34 | EN
EN | 35
Summary of Contents for AstroTec-868 bidi
Page 24: ...46 EN EN 47...
