elero AstroTec-868 bidi, Operating Instructions Manual

Warnhinweise

Programming

FUNCTION (only when the operating device is disconnected, 
only for qualified electricians)
ROLLER SHUTTER/BLIND, DRIVE CONTROLLER/ GROUP 
CONTROLLER, RUNNING TIME 
(Selection of shutter/blind, selection of the drive controller/group 
controller, running time of the roller shutter/blind)

+

O K

FUNCTION

ROLLER SHUTTER/

BLIND

OK

OK

OK

+/–

+/–

+/–

DRIVE CONTROLLER/

GROUP CONTROLLER

RUNNING

TIME

Operating

mode

OK

1.  Press the MENU button.
2.    To select the FUNCTION menu, press the 
  + button until FUNCTION appears.
3.  Confirm by pressing OK. ROLLER SHUTTER/BLIND will appear.
4.   You can select either roller shutter or blind using the +/- button.
5.  Confirm by pressing OK. RUNNING TIME will appear.
6.  

 You can set the required running time using the +/- button. 
(Default setting: 120 seconds).

7.  

Confirm by pressing OK. EXPERT MODE ON/OFF will appear. 

8.  You can make the setting you require using the +/- button.
9.   Confirm your selection by pressing OK.  INITIAL OPERATION 

will appear. 

10. Confirm by pressing  OK. 
11.  Press the MENU button to switch to operating mode.

Technical data / Battery replacement / 
Cleaning 

  Nominal voltage 

3 V DC

  Battery type 

2 x LR 03 (AAA)

  System of protection 

IP20

  Permissible ambient temperature 

0 to +55 °C

  Type of installation 

Wall-mounted

  Radio frequency 

868 / 915 MHz 

Technical data 

Battery replacement

1.  Remove the batteries. 

2.   Insert the new batteries 

 properly.

LR03 (AAA)

LR03 (AAA)

+

+

--

+

+

--

Note!   The batteries must be 

replaced within one minute. 
When changing the batte-
ries, ensure that no buttons 
are pressed.

Cleaning

Clean the device with a damp cloth only. 
Do not use a cleansing agent since this could damage the 
plastic.

42 | EN 

EN | 43