elero AstroTec-868 bidi, Operating Instructions Manual

Warnhinweise

Light sensors / Explanation of functions

EN | 9

Initial operation / Factory settings

8 | EN 

Initial operation

To activate the AstroTec-868/-868 bidi/-915 bidi timer, touch any 
button on the device. To select the language required use the 
+/- buttons and confirm your selection with the OK button. The 
AstroTec-868/-868 bidi is now in  automatic operating mode.

Factory settings

TIME/DATE:  – Current GMT and current date

PROGRAMME: – ASTRO 

→

 BLOCK 

→

 IDLE PERIOD (1-5)

▲

 06:30 HRS

▼

  No default idle period 

IDLE PERIOD (6,7)

▲

 08:00 HRS

▼

  No default idle period 

SETTING: 

– HOLIDAY OFF

 – 

 light sensor SUN 05 sunlight value
(if light sensor is connected)

– PROG 1 END LIMIT, LONDON

– SUMMER/WINTER ON

FUNCTION: – 

ROLLER SHUTTER, EXPERT MODE OFF

Note:  

Press the Reset button (with a ballpoint pen or similar 
object) to restore the factory settings of the

          AstroTec 868/-868 bidi.
 Exception: 

Function, language and city menu levels.

Light sensors

Note:  If you wish to connect a light sensor to the 

AstroTec 868/-868 bidi, the instructions provided with 
the light sensor must be followed.

Explanation of functions

MAN/AUTO sliding switch
In the “MAN  ” sliding switch setting, only manual command  
controls are executed.
In the “AUTO  ” sliding switch setting, manual and automatic 
 command controls are carried out (e.g. shade function, time, 
astro function,...)

Transmission control light

A radio signal is indicated when the transmission control light 
comes on. If the UP, STOP and DOWN buttons or programming 
button P on the transmitter are held for a longer period, the 
transmission control light will go out after 3, 6 and 9 seconds. 
This function is a counting aid. After 12 seconds the transmission 
control light will go out  completely.
If the batteries are low, the transmission control light flashes during 
the transmission process. The transmitter power and/or radio range 
is reduced when the batteries are low. If the transmission control light 
no longer lights up when a button is pressed, the batteries have to be 
replaced. 

Operating mode

The time is shown in the display.

OK button

When the OK button is pressed, the values currently displayed are 
saved.