USA-20
US
A
USA-19
Programming additional transmitters/
Deleting transmitters
Deleting individual transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Press the following buttons
simultaneously
:
• Programming button
P
(on back of device)
•
STOP
button (on front of device)
2. Keep these two buttons pressed until the LED goes out briefly
(approx. 3 seconds).
Deleting all transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Press the following buttons
simultaneously
:
• Programming button
P
(on back of device)
•
UP
button
•
STOP
button
•
DOWN
button
2. Keep all of these buttons pressed until the LED goes out.
on front of device
k
Programming additional transmitters
To programme additional transmitters in one receiver, please proceed
as follows:
1. Press the
UP
,
DOWN
and programming button
P
on a transmitter
that has already been programmed in the receiver until the LED
goes out.
2. To define the keyboard layout, press the
UP
button on the handheld
transmitter as soon as the shutter/blind begins to move upwards
(after approx. 1 second).
The shutter/blind will come briefly to a halt.
As soon as the shutter/blind begins to move again, press the
DOWN
button on the handheld transmitter.
The shutter/blind will come to a stop.
The transmitter or this channel has been successfully programmed.
Programming radio channel settings
Programming radio channel settings
Programming transmitter/channel
Prerequisite:
The drive must be installed.
1. With pre-installed electric receivers, the fuse must be
disconnected and reconnected after a few seconds.
The drive will then remain in programming mode for
approximately 5 minutes.
2. Position yourself in front of the roller shutter/blind with the
AstroTec-915 in your hand
LR03 (AAA)
Programming button
P
3. Press programming button
P
on the back of the device
briefly. The shutter/blind will
automatically begin to move
up and down. This will hap-
pen for approximately 2
minutes.
4. To define the keyboard layout, press the
UP
button of the
AstroTec-868 (located on the front of the device) as soon as the
shutter/blind begins to move upwards (after approx. 1 second).
The shutter/blind will come to a halt briefly.
As soon as the shutter/blind begins to move again, press the
DOWN
button on the AstroTec-915.
The shutter/blind will come to a stop.
The AstroTec-915 has been successfully programmed.
