WARNING
Risk of injury due to electric current.
Risk of electric shock
►
Separate power supply cables physically and discharge
any energy accumulators still charged. After switching off
the device, wait at least 5 minutes so that the motor can
cool down and the voltage can be discharged from the
capacitors.
►
During disassembly work above head height, use
suitable, inspected and structurally stable climbing aids.
►
Work on the electrics may only be performed by
personnel described in the section "Safety notes
on electrical installation".
Removal for scrap
The international, national and regional laws and
regulations prevailing at the time of scrapping the
product must be observed.
Ensure that materials and components are recycled,
dismantled and separated properly in addition to observing
the environmental and health hazards relating to recycling
and disposal.
CAUTION
Environmental damage in case of incorrect disposal
►
Electrical scrap and electronic components must be
handled as special waste and may only be disposed of by
approved specialist companies.
►
Groups of materials such as various types of plastics and
metals must be separated before recycling/disposal.
Disposal of electrical and electronic components
The disposal and recycling of electrical and electronic
components must be carried out in accordance with the
relevant laws and national regulations.
11 EU Declaration of Conformity
elero hereby declares that this device is in compliance
with all applicable regulations of the Machinery Directive
2006/42/EC. The full text of the EU Declaration of
Conformity is available at the following Internet address:
www.elero.de/downloads-service/
12 Technical data and dimensions
The following variants are available:
• VariEco L RH drive with round head (standard)
The technical data specified is subject to tolerance factors
(according to applicable standards) and refer to an ambient
temperature of 20° C.
6 | EN
©
elero
GmbH
Adjustment of the end positions | Troubleshooting
Take into account any possible changes to the length of the
blind due to temperature fluctuations or weather influences.
Allow for a safety margin.
6
Troubleshooting
Problem / fault Possible cause Remedy
• The drive does
not switch
off in the end
position via the
limit switches
• Drive does
not react
• The limit
switch crown
is not being
driven
• Correct the
assembly, and
adjust the limit
switches via
the limit switch
setting screws
• Drive does
not react
• Incorrect
connection
• Readjust
connection
Fig. 6 Troubleshooting with the VariEco L RH
7
Servicing
The VariEco L RH is maintenance-free.
8
Repairs
Please contact your specialist if you have any questions.
Please always provide the following information:
• Item number and designation on the type plate
• Type of fault
• Unusual events preceding fault
• Accompanying conditions
• Your own theories regarding the cause of the problem
9
Manufacturer's address
elero
GmbH
Antriebstechnik
Maybachstr. 30
73278 Schlierbach
Germany
Telephone: +49 7021 9539-0
Fax:
+49 7025 9539-212
info@elero.de
www.elero.com
Please visit our website if you require a contact partner
outside Germany.
10 Disassembly and disposal
After unpacking, dispose of the packaging in accordance
with the valid regulations.
Dispose of the product in accordance with the relevant
regulations when you no longer need it.
Environmental information
No superfluous packaging materials have been used.
The packaging can be easily separated into three
material types: cardboard (box), polystyrene (padding)
and polyethylene (bag, protective foam).
The device is made of materials that can be reused if
dismantled by a specialist company. Please note the local
regulations on disposal of packaging materials and old
appliances.
On disassembly, additional dangers must be reckoned with,
which do not occur during operation.
