USA-12
US
A
USA-11
Operating voltage
3 V DC
Battery requirements
2 x LR 03 (AAA)
System of protection
IP 20
Permissible ambient temperature
–10 to +55 °C
Operating frequency
915,3 MHz
Dimensions in mm
L 121 x W 43 x H 23
Deleting individual transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Open the front cover on the device and press the following
buttons
simultaneously
:
• Programming button
P
•
STOP
button
2. Keep these two buttons pressed until the LED goes out briefly.
Deleting all transmitters
Disconnect the fuse – and reconnect after a few seconds.
1. Open the front cover on the device and press the following
buttons
simultaneously
:
• Programming button
P
•
UP
buttpm
•
STOP
button
•
DOWN
button
2. Keep all of these buttons pressed until the LED flashes 3 times.
Technical data
The maximum radio range is 25 m indoors and 350 m outdoors.
Deleting radio channel settings/Technical data
Intermediate position for roller
shutter/awning/venetian blind
Adjustment to Pos
B
Prerequisite:
The transmitter has been programmed.
1. Press the
UP
button twice
in quick succession
.
2. The drive will adjust the curtain/canopy/blind into the stored
intermediate position. If no intermediate position is stored,
the curtain/canopy/blind is automatically adjusted into the
lower limit position.
Adjustment to Pos
V
(roller shutter, awning)
Prerequisite:
The transmitter has been programmed.
1. Press the
UP
button twice
in quick succession
.
2. The curtain/canopy is adjusted into the stored ventilation
position. If no ventilation position is stored, the curtain/
canopy is automatically adjusted into the upper limit position.
Adjustment to Pos
V
(venetian blind)
Prerequisite:
The transmitter has been programmed.
1. Press the
UP
button twice in
quick succession
.
2. The blind is adjusted into the stored reverse position. If no
reverse position is stored, the blind is automatically adjusted
into the lower limit position.
Deleting Pos
B
1. Press the following buttons
simultaneously
:
•
DOWN
button
•
STOP
button
2. Keep these two buttons pressed until the LED goes out briefly.
Deleting Pos
V
1. Press the following buttons
simultaneously
:
•
UP
button
•
STOP
button
2. Keep these two buttons pressed until the LED goes out briefly.
