18
EN
DD51-E
Direct drive electronic position indicators
Models all rights reserved in accordance with the law.
Always mention the source when reproducing our drawings.
3. Assembly
1. Drill a Ø 6x10 mm hole in the body of the machine with
a 22 mm centre distance from the shaft to fit the rear
referring pin.
2. Fit the indicator onto the shaft and make sure that the
referring pin fits into the hole.
3. Clamp the bushing to the shaft by tightening the grub
screw with hexagon socket and cup end, according to
UNI 5929-85.
4. Turning on the system
After you have read and understood the section “Safety
Instructions”, proceed by switching on the indicator.
To turn the indicator on hold
while pressing the key
.
The display will light up and the indicator will be ready
to be used.
4.1 Turning off the system (only for storage)
To turn the system off enter the programming mode, select
the
rESEt
parameter then press the key
. At this
point, press the button
for 5 seconds; the display
will turn off and the indicator will go into low power mode
of the battery.
