Preload Music
The player comes preloaded with some demo music. If you want to preload your
own music before site installation, you should change the player’s IP address to be
within the subnet of the managing PC. You’ll then be able to use the server pro-
gram and preload the music. Afterwards, you should change the player’s IP address
back to the real one for site installation.
Site Installation
Before site installation, the player’s IP address must have been properly configured
as described previously. Depending on the application, the player may be connected
to the Internet directly, via a LAN, or not connected to the Internet at all. There are
firewall issues in most cases, and you’ll need the help of your network administrator
to create a passage through the firewall (usually via port forwarding) or the player
may not be accessible.
Hook up all the necessary wires and cables securely to the player. There are two
audio outputs and only one needs to be used. The 8 Ohm output should be used in
most cases. The 600 Ohm output should be used only if the phone system has a RJ-
11 connector for the onhold music.
Turn on the player and turn up the volume. Press the Monitor button down to turn
on the speaker and you should be able to hear the preloaded music now. Adjust the
volume if necessary - both the speaker and the audio output will be affected. The
speaker can be turned off by pressing the Monitor button again. The speaker may
be left on or off for normal operation.
- 4 -
