02/02/22
User Manual HPS/T 62000590_07_
17
The buttons UP and DOWN, respectively indicated with a little arrow upwards and downwards,
permit a continuous variation of the output voltage; the speed of the output voltage variation
depends on time the button is pushed, as time increases, the speed of the output voltage variation
progressively increases.
Instead, if you want to set a fixed output voltage, you can use the numeric keyboard situated on
the right side of the control panel.
To set a fixed output voltage proceed in the following way:
1.
Push the button PROGRAM (the corresponding led switches on)
2.
Push the button VOLT (the volt display switches off)
3.
Digit the required voltage through the numeric keyboard (the numbers are visualized on
the display)
4.
Push ENTER.
After pushing ENTER the display begins to blink, this is to indicate the output is going to the set
voltage, as soon as the connection takes place, the display stops to flash and the PROGRAM led
shuts off.
In case of error, you can push the button CLEAR which causes the exit from the programming
routine.
The maximum voltage is equal to the set off range.
Moreover, if the set off voltage is not coherent with the set off range (for example the setting of a
voltage exceeding the range) the datum is not accepted after pushing ENTER.
3.2.
RANGE SETTING
The HPS/T range buttons allows to make use of the full output power at different voltages.
There are two different ranges: 300 Volt and 150 Volt.
