GSM Gateway Proline Digital
User Manual
GWC+POL=n ,
where:
if n=0 – function is disable
if n=1 – function is enable and the polarity will reverse at the beginning of
every call.
5.3 Volume of the signal in handset
You can set the volume of the signal in the handset.
The setting in configuration file is:
GWC+SPVOL=n
, where “n” can be adjust from
0 to 100.
5.4 Time interval between dial and connection
It is possible to change time interval between dialing and connecting. It give
you the opportunity to dial the digits of one number slower of faster.
You can set this function in configuration file and the setting is:
GWC+LDT=n
where ''n'' is in time interval between 0 to 65000 ms.
It is strongly recommended to choose a value between 2000 and 5000.
5.5 Default settings
You can restore default setting of the unit every time you want. Just go to
installation CD and upload configuration file without make any changes.
Default settings:
•
Set time interval between dialing and connecting – 3000 ms
•
CLIR – no
•
Volume of handset – 50
•
Polarity reverse – yes
•
Incoming call restriction – no
•
Line impedance – 600 Ω
6.Technical support
If you encounter problems while using the device and you are not able to solve
them please follow these direction:
•
Please check once again the SIM card, antenna and power supply to be
connected as in it describe in User manual.
•
Please check the PIN code of SIM card. It must be disabled
10
