49
7.4.
The oven has Class I of electrical safety and is designed for connection to the
power sources 220-240 V, 50 Hz.
ATTENTION!
INTENSITY OF CURRENT TO ENSURE THE NORMAL
OPERATION OF THE OVEN SHOULD BE AT LEAST 16 A.
IF THE CURRENT VALUE IS LESS THAN 16 A, IT IS
NECESSARY TO CALL A QUALIFIED ELECTRICIAN TO
REPLACE THE WIRING.
7.5.
Prior to connection it is necessary to check conformity of the electrical
parameters of the oven (necessary data is indicated on the factory nameplate placed
below the device) to the power network.
7.6.
The oven is equipped with a network cable with a plug. The socket should match
the size of the plug and have grounding contacts.
7.7.
The socket shall be in an easily accessible place for quick access to the plug. Make
sure the wire is as close to the oven as possible.
7.8.
If the appliance is not used for a long time, remove the plug from the socket.
7.9. It is necessary to remove the back panel of the cabinet for free circulation of air.
The panel in which the oven is inserted must have a gap at the back of at least 75 mm.
7.10. It is not recommended to install the appliance near refrigeration units or freezers,
as heat can disable them.
7.11. The distance between the cooking surface and the oven should be at least 5 cm,
unless otherwise indicated in the cooking surface manual
7.12. The installation options, installation dimensions and hole size for installation of
the oven are shown in the figure.
