If any of the mentioned above actions were made, panel can be use, however its additional, correct
configuration would allow more efficient operation of the system. By default, the panel is programmed to
cooperate with 255 handsets - within full range. Selection of any number starts the calling (even when a
handset of selected number is not present in the system, it is not connected).
The digital panel EEPROM memory stores default administrator and users (tenants) codes. Default code
table that depend on the panel serial number is different for each manufactured panel
!
Default administrator (fitter) code is provided by the manufacturer. It can be changed any time,
after previous providing current code.
4.3
Establishing a connection
To establish a connection (depending on the set option in menu):
1.
using the keyboard, select flat number with which you want to connect and confirm
with the key„
or wait. E.g. 123 will cause the selection of number 123.
2.
using the keyboard, select flat number with which you want to connect and confirm with the key
To delete erroneously entered number or terminate the calling, press „#”. Panel sends a ringing signal for
a period of time set in the memory
. If during the calling, handset in a called flat is operated, the connection
3
General and individual codes can be changes arbitrarily from the menu level.
4
Fitter options allow changing the settings, so that the calling is automatic, after a set period of time, without the
necessity to confirm with the key „ ”.
5
See General settings / Talking options / Ringing time
14
Figure 9: Potentiometers Loudness, Microphone,
Balance.
