25
25
Enable or disable SATA Device.
SATA Mode Selection
Determines how SATA controller(s) operate.
Software Feature Mask
Configuration
RAID OROM/RST driver will refer to the SWFM configuration to enable or disable the
storage features.
Aggressive LPM Support
Enable PCH to aggressively enter link power state.
Options for each SATA port :
Port 0
Enable or disabled SATA Port.
Spin Up Device
On an edge detect from 0 to 1, the PCH starts a COMRESET initialization sequence to
the device.
SATA Device Type
Identify the SATA port is connected to Solid State Drive or Hard Disk Drive.
2.3.11 Acoustic Management Configuration
Figure 4-3-11 : Acoustic Management Settings
Acoustic Management Configuration
Option to enable or disable Automatic Acoustic Management.
2.3.12 Network Stack Configuration
Figure 4-3-12 : Network Stack Settings
Network Stack
Enable/disable UEFI Network Stack.
Summary of Contents for LPC-P150S-2VEX
