30
30
2.4.3 Memory Information of System Agent (SA)
Figure 4-4-3 : Memory Information
Display memory information.
2.4.4 PCH-IO Configuration
Figure 4-4-4 : USB Settings
PCH LAN Controller
Enable or disable onboard NIC.
Wake on LAN
Enable or disable integrated LAN to wake the system. (The Wake On LAN cannot be
disabled if ME is on at Sx state).
Serial IRQ Mode
Configure Serial IRQ Mode.
State After G3
Specify what state to go to when power is re-applied after a power failure (G3 state).
S0 State: Always turn-on the system when power source plugged-in. S5 State:
Always turn-off the system when power source plugged-in
Summary of Contents for LPC-P150S-2VEX
