Operation modes and Commissioning
- 42 -
NOTE!
If a power cycle happens starting from teach mode and both reference positions have been
learned, LIMAX33 CP-00 will restart in normal mode for the case that LIMAX33 CP-00 does
not need a floor table , reference positions will be available. Learning process is finished.
11.2.3
Learning the Floor Table
After learning the reference positions, an inspection trip between the inspection limit switches is possible. In this
phase, the technician can teach the lift control by performing an inspection trip.
After any necessary works to teach the lift control is finished, the elevator is set to normal (the LIMAX33 CP-00
remains in teach mode).
The elevator can now be moved by car call. The speed is limited to pre-tripping speed teach
14.1 .
1.
The technician now drives to one floor after the other.
2.
At each floor, he opens the doors and checks if the door thresholds are level with the floor ground.
If not, he can adjust the position of the cabin by correcting the position of the floor in the lift
control and then he induces the control to make a correction.
3.
When the door thresholds are level with the floor ground, the technician signals to the lift control that
this floor should now be learned by LIMAX33 CP-00.
The technician must not signal that LIMAX33 CP-00 should learn a floor position before the
cabin is level to the floor ground.
When doing this, the number of the floor (index of the floor table, refer also to CANopen-
Specifications must also be included in the signal (numbering from bottom to top, starting with
number 1 for the lowest floor).
When doing this, the side of the floor (first side, second side or both sides ) must also be in-
cluded in the signal
The cabin must be at standstill.
4.
The control has to pass on this signal via CAN bus to LIMAX33 CP-00.
5.
Repeat the last steps until all floors are learned.
WARNING!
The technician must not be on the cabin roof or in the shaft if the elevator is not in inspection.
Summary of Contents for LIMAX33 CP-00 SERIES
Page 91: ...91 Notes...
