11
2
Wash metal filters as needed in dishwasher or hot
detergent solution.
3
Reinstall the filter by making sure the spring release handles
are toward the front. Insert metal grease filter into upper
track.
4
Pull the spring release handle down.
5
Push up on metal filter and release handle to latch into place.
6
Repeat steps 1-5 for the other filter.
Replacing a LED lamp
Turn off the range hood and allow the LED lamp to cool. To
avoid damage or decreasing the life of the new bulb, do not
touch bulb with bare fingers. Replace bulb using tissue or
wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1
Disconnect power.
2
Push up on the lens and turn it counterclockwise.
3
Remove the bulb and replace it with a 120-volt, 6.5-watt
maximum LED bulb with a GU10 base. Turn it clockwise
to lock it into place.
4
Repeat steps 2-3 for the other bulb if needed.
5
Reconnect power.
Available accessories
Recirculation kit -
KIT02770
(for non-vented installations only)
The charcoal filters cannot be cleaned. It should be
replaced every 4-6 months (depending on hood usage).
1
Cover the grill that protects the suction motor with the
carbon filter so that the slots on the filter correspond to
the pins on the sides of the motor protection grill.
A
B
C
A. Charcoal filter
B. Pins
C. Blower motor
2
Remove the cable ties in the carbon filter and turn the
carbon filter clockwise to block them (bayonet fixing).
Face Panel Rear Extension -
KIT02773
(for 30” x 18” [76.2 cm x 45.7 cm] cabinet)
Summary of Contents for EAS430SS
Page 24: ......
