5
LOCATION REQUIREMENTS
Product dimensions
A
I
H
F G
E
D
C
B
Model
EAS430SS
A
3/8” (10 mm)
B
30” (76.2 cm) or 36” (91.4 cm)
C
26” (66.1 cm)
D
2” (5.1 cm) or 5” (12.7 cm)
E
10
3
⁄
4
” (27.4 cm)
F
3/4” (19 mm)
G
11
7
⁄
8
” (30.2 cm) or 17
7
⁄
8
” (45.4 cm)
H
9
1
⁄
8
” (23.1 cm)
I
13
5
⁄
8
” (33.7 cm)
For gas and electric ranges installation: Mount this hood so
that the bottom edge is at minimum 30”(76.2 cm) above the
cooking surface.
Installation clearances
F
A
B
C
D
E
A. 12” (30.5 cm) min. upper
cabinet height
B. 30” (76.2 cm) or 36” (91.4
cm) cabinet opening width*
C. 24” (61.0 cm) min. from elec-
tric cooking surface, 27” (68.6
cm) min. from gas cooking
surface, 36” (91.4 cm) sugges-
ted max. bottom of cabinet to
cooking surface
D. 12” (30.48 cm) cabinet opening
depth*
E. 15” (38.1 cm) min. clearance
upper cabinet to countertop
F. 36” (91.4 cm) base cabinet
height
*
NOTE
: 30” (76.2 cm) cabinet width can be 12” (30.5 cm)
deep or 18” (45.7 cm) deep cabinets.
36” (91.4 cm) cabinet width requires 18” (45.7 cm)
deep cabinets.
For 18” (45.7 cm) deep cabinets, an optional Face Panel
Rear Extension (30” [76.2 cm]) must be purchased sepa-
rately. See the “Available accessories” section to order.
Venting requirements
•
Vent system must terminate to the outdoors, except for no
vented (recirculating) installations.
•
Do not terminate the vent system in an attic or other
enclosed area.
•
Do not use a 4” (10.2 cm) laundry-type wall cap.
•
Rigid metal vent is recommended. Plastic or metal foil
vent is not recommended. The length of vent system and
number of elbows should be kept to a minimum to provide
efficient performance.
For the most efficient and quiet operation:
•
Use no more than three 90° elbows.
•
Make sure there is a minimum of 24” (61 cm) of straight
vent between the elbows if more than 1 elbow is used.
•
Do not install 2 elbows together.
•
Use clamps to seal all joints in the vent system.
•
The vent system must have a damper.
•
Use caulking to seal exterior wall or roof opening around
the cap.
•
The size of the vent should be uniform.
Summary of Contents for EAS430SS
Page 24: ......
