8
Cabinet Installation
NOTE:
Your cabinet must be able to support at least 88 lb (40kg).
1
Drive a mounting screw (from the hardware package)
partway into each center of the narrow neck of the keyhole
slots marked on the cabinet bottom.
2
Install the 4 - 4 x 8 mm mounting screws. Leave a
1
⁄
4
” (6.4 mm)
gap between the wall and the back of the screw head to
slide range hood into place
1
⁄
4
” (6.4 mm).
3
Fix the wiring conduit of the hood.
4
Slide the hood back against the cabinet. Tighten the
mounting screws. Be sure the screw heads are in the narrow
neck of the keyhole slot.
5
Drive 2 pieces of the selected screws in the security holes
(See the image below).
A
B
A. 4- 4x8 mm mounting screws
B. Security screws
Wall Installation
Install framing for hood support
1
Mark the screw hole locations indicated in the “Outside
rear exhaust” figure.
2
If drywall is present, cut away enough drywall to expose
2 vertical studs at the indicated holes location. Install two
horizontal supports between two wall studs at the bottom
and upper mounting holes installation location.
3
The horizontal support must be flush with the room side
of the studs. Use cleats behind both sides of the support
to secure wall studs.
4
Reinstall drywall and refinish.
View from rear
Mounting
Support
Centerline of
Installation
Space
IMPORTANT: Framing must be capable
of supporting 100 lbs.
Cleats
5
Cut holes at marked locations for duct and electrical wiring.
Mounting the hood
1
Drive a mounting screw (from the hardware package)
partway into each center of the narrow neck of the keyhole
slots marked on the wall’s support frame.
2
Install the 2 pieces of the selected screws on the mountings
screws location (see the image). Leave a
1
⁄
4
” (6.4 mm) gap
between the wall and the back of the screw head to slide
range hood into place.
1
⁄
4
”
(6.4 mm)
3
Fix the wiring conduit of the hood.
4
Slide the hood back against the wall. Tighten the mounting
screws. Be sure the screw heads are in the narrow neck of
the keyhole slot.
A
B
C
B
A. Mounting screws
B. Upper security screws (Wall Installation)
C. Lower security screws (Wall Installation)
5
Drive 2 pieces of the selected screws in the upper security
screws location (see the image above).
6
Drive 2 pieces of the selected screws in the lower security
screws location (see the image above).
7
Connect Ductwork to hood.
Electrical connection
I
WARNING
ELECTRICAL SHOCK HAZARD.
I
WARNING
DISCONNECT POWER BEFORE SERVICING.
REPLACE ALL PARTS AND PANELS BEFORE OPERATING.
FAILURE TO DO SO CAN RESULT IN DEATH OR ELECTRICAL
SHOCK.
• Remove the knockout and the Junction box cover and
install the conduit connector (cULus listed) in junction box.
A
E
B
F
C
D
A. White wires
B. Black wires
C. UL listed wire connector
D. Green (or bare) and yellow-green
ground wire
E. Home power supply cable
F. UL listed or CSA approved ½” strain relief
