ELICA Elica Hidden 2.0 IX 60 Instruction On Mounting And Use Manual Download

Page: 20 / 160

Use

The hood is designed to be used either for exhausting or filter
version.

Extraction version

In this case the fumes are conveyed outside of the building by
means of a special pipe connected with the connection ring
located on top of the hood.

CAUTION

The exhausting pipe is not supplied and must be purchased
apart.
Diameter of the exhausting pipe must be equal to that of the
connection ring.

CAUTION

If the hood is supplied with active charcoal filter, then it must
be removed.

Connect the hood and discharge holes on the walls with a
diameter equivalent to the air outlet (connection flange).
Using the tubes and discharge holes on walls with smaller
dimensions will cause a diminution of the suction performance
and a drastic increase in noise.

Any responsibility in the matter is therefore declined.

Use a duct of the minimum indispensable length.

Use a duct with as few elbows as possible (maximum
elbow angle: 90°).

Avoid drastic changes in the duct cross-section.

Filtration version

The aspirated air will be degreased and deodorised before
being fed back into the room.
In order to use the hood in this version, you have to install a
system of additional filtering based on activated charcoal.

Installation

Mounting

Before beginning installation:

•

Check that the product purchased is of a suitable size for
the chosen installation area.

• Remove the charcoal (*) filter/s if supplied (see also

relative paragraph). This/these is/are to be mounted only
if you want lo use the hood in the filtering version.

• Check (for transport reasons) that there is no other

supplied material inside the hood (e.g. packets with
screws (*), guarantees (*), etc.), eventually removing
them and keeping them.

In the case of the presence of panels and/or walls and/or
lateral wall units check that there is sufficient space to install
the hood and that access to the command panel is easy.

To remove the hood from the wall unit,

perform the

mounting steps in reverse order.

Caution!

Use suitable cut resistant gloves.

Elica Connect

The hood features a WiFi function for remote connection via
the Elica Connect app.
Minimum system requirements:
•

2.4GHz WiFi b/g/n wireless router

•

Android or iOs Smartphone. Via the stores, check that
the app is compatible with the operating system your
Smartphone is running.

Note:

The ELICA manufacturer declares that this model of

household appliance with WiFi module radio equipment
complies with Directive 2014/53/EU.
The radio equipment operates within the 2.4GHz ISM
frequency band, the maximum radio frequency power
transmitted does not exceed 20 dBm (e.i.r.p.).

Warnings:

•

Data protection.

The data that the connected device

detects is collected to allow for all the services of the
connected appliance to be used. Further information on
how the collected data is processed and on the privacy
policy is available at www.elica.com.

•

Availability in different countries.

The Elica Connect

service is available in specific countries. For further
information, see the dedicated section at www.elica.com.

•

Future changes.

Elica reserves the right to make any

changes deemed useful to improve the Elica Connect
service. As a result, the descriptions contained in this
manual are not binding and should be treated as purely
indicative.