10
Range Hood Care
Cleaning
Do not spray cleaners directly to the control while cleaning the
Hood. The cooker hood should be cleaned regularly (at least
with the same frequency with which you carry out maintenance
of the fat filters) internally and externally. Clean using the
cloth dampened with neutral liquid detergent. Do not use
abrasive products.
DO NOT USE ALCOHOL!
I
WARNING:
Failure to carry out the basic cleaning recommendations of the
cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate maintenance
or failure to observe the above safety recommendations.
Grease filter
Traps cooking grease particles.
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle. When washed
in a dishwasher, the grease filter may discolour slightly, but
this does not affect its filtering capacity.
To remove the grease filter
1
Remove the grease filter bracket.
B
A
A.
Bracket
B.
Grease filter bracket screws (2)
2
Pull the spring release handle to remove the grease filter.
A
3
Reinstall the filter by placing the back edge in the channel
at rear of hood.
4
Replace the bracket using the screws that were previously
removed in step 1.
Replacing a LED Lamp
The LED lights are replaceable by a service technician only.
See the service contact information in this page below.
Charcoal filter
If the model is not vented to the outside, the air will be
recirculated through disposable charcoal filter that help remove
smoke and odors.
The charcoal filter cannot be cleaned.
It must be replaced.
The charcoal filter is clipped inside of the metal grease filter
The charcoal filter should be replaced every 4-6 months
(depending on hood usage).
NOTE:
DO NOT rinse, or put charcoal filter in an automatic
dishwasher.
NOTE:
Charcoal filter is not included with the hood.
It must be ordered from your supplier.
Order the needed kit specifying your hood model and width
size.
Charcoal filter placement (Recirculating accessories)
Fit the charcoal filter mattress on the upper side of the grease
filter.
Use provided rods to fix it in place.
NOTE:
Place each rod into the hole in A side and then into the
next hole in B side of the charcoal filter as the image below.
Rod
Charcoal filter
Holes in
A Side
Holes in
B Side
