ELICA Interstellar Instruction On Mounting And Use Manual Download

Page: 30 / 100

WARNING! Failure to install the screws or fixing device in
accordance with these instructions may result in electrical
hazards.
Do not use with a programmer, timer, separate remote control
system or any other device that switches on automatically.
This appliance is marked according to the European directive
2012/19/EC on Waste Electrical and Electronic Equipment
(WEEE). By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product.

The symbol

on the product, or on the documents

accompanying the product, indicates that this appliance may
not be treated as household waste. Instead it should be taken
to the appropriate collection point for the recycling of electrical
and electronic equipment. Disposal must be carried out in
accordance with local environmental regulations for waste
disposal.
For further detailed information regarding the process,
collection and recycling of this product, please contact the
appropriate department of your local authorities or the local
department for household waste or the shop where you
purchased this product.

Appliance designed, tested and manufactured according to:
• Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC
62233.
• Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO
5168; EN/IEC 60704-1; EN/IEC 60704-2-13; EN/IEC 60704-3;
ISO 3741; EN 50564; IEC 62301.
• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2;
EN/IEC 61000-3-2; EN/IEC 61000-3-3. Suggestions for a
correct use in order to reduce the environmental impact:
Switch ON the hood at minimum speed when you start
cooking and kept it running for few minutes after cooking is
finished. Increase the speed only in case of large amount of
smoke and vapour and use boost speed(s) only in extreme
situations. Replace the charcoal filter(s) when necessary to
maintain a good odour reduction efficiency. Clean the grease
filter(s) when necessary to maintain a good grease filter
efficiency. Use the maximum diameter of the ducting system
indicated in this manual to optimize efficiency and minimize
noise.

Use

The hood has been made for use in the internal recirculating
filtering version.
Cooking fumes and steam are aspirated inside the hood,
filtered and cleaned, passing through the fat filter/s and the
carbon filter/s that MUST be supplied with the hood.

Important

It is possible to buy an extraction operation Kit.
In this case the charcoal filter must not be installed.
Furthermore, the use of the extraction kit may require a different
installation of the hood from what shown in this manual; therefore,
before starting the installation of the hood, buy the extraction kit
and consult the instructions enclosed with the kit.

Installation

Specialised personnel must carry out both the electrical and
the mechanical installation.

The minimum distance between the supporting surface for the
cooking equipment on the hob and the lowest part of the range
hood must be not less than 50cm from electric cookers and 65cm
from gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater
distance, this must be adhered to.

Electrical connection

The mains tension must correspond to the tension shown on the
characteristic label situated inside the hood.
The product is meant for connecting directly to the mains supply,
therefore apply a regulation bipolar switch that ensures complete
disconnection from the mains in the conditions of category III over-
tension, conforming to the installation rules.

Warning! Detail B (fixing bracket to the ceiling) is equipped
with a conductor (yellow-green) that must be connected to
the earth of the domestic electrical plant. Fig. 16-17

ATTENTION!

Be particularly careful about positioning

the

excess cable. Failure to observe this indication could cause grave
damage to the apparatus and/or an electric shock to the user or
the installer.

Warining!

Changing the interconnection cable must be carried out

by the authorised technical assistance service.

Mounting

Before beginning installation:

•

Check that the product purchased is of a suitable size for the
chosen installation area.

•

Remove the charcoal (*) filter/s if supplied (see also relative
paragraph). This/these is/are to be mounted only if you want
lo use the hood in the filtering version.

•

Check (for transport reasons) that there is no other supplied
material inside the hood (e.g. packets with screws (*),
guarantees (*), etc.), eventually removing them and keeping
them.

This type of cooker hood must be fixed to the ceiling.

Very heavy product; hood handling and installation must be
carried out by at least two persons.

Expansion wall plugs are provided to secure the hood to most

types of walls/ceilings. However, a qualified technician must verify
suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take the
weight of the hood.

Do not tile, grout or silicone this appliance

to the wall. Surface mounting only.