28
English
Note:
Tilting the machine backwards to slightly lift the blades while steering is recommended. This is to
avoid damaging the lawn.
• When you reach the end of a strip and want to turn around to work the adjoining strip, you
push the handlebar down slightly to lift the blades from the surface. The blades should be lifted
approximately 3 to 4 centimetres from the surface. Push the machine in the desired direction
using the handlebar. Once turned 180°, lower the machine with the front wheels back to the
ground.
• With this turning movement, you do not have to switch the blades off each time.
Caution:
when lifting the front wheels, with the blades in operation, there may
be projectiles. Always make sure that there are no persons, animals or fragile
objects in the projectile area in front of the machine.
• When dethatching the second
lane, the left front wheel should
be driven just (5 cm) past the
verge of the material in the fi rst
lane. Make sure that there is a
small overlap between strips.
• The moss and felt will be collec-
ted by the discharge system on a
strip on the adjacent dethatched
working area.
• This lane pattern should be
repeated until the entire surface
has been worked.
Please note:
If the discharge jack suddenly has to process too much material, the inspection
hatch may be pushed open. In this case, immediately release the drive lever so that the machine
slows down. This stops the fl ow of new material and gives the discharge mechanism time to
process the material from the housing. The inspection hatch will close automatically under spring
pressure. If necessary, change the angle setting of the defl ector fl ap to create more opening and
make it easier for the volume of material to be discharged from the discharge jack.
Lane 1
Lane 1
Lane 2
Lane 2
5 cm
Summary of Contents for C550 ZR
