.
20
Nederlands
• A standard suction hose measures 3.5 metres in length and thus provides suction over a width
of 7 metres. This must be taken into consideration before defining the work route.
• In view of the risk of carbon monoxide poisoning from the exhaust, the machine must never be
run in a closed environment.
9.5.2 During work
• The operator must be alert while he’s working. As long as he is operating the machine, his full
attention must be on the job.
• Start the engine as described in the preparations section above.
• The engine will run only with the suction arm attached to the suction opening of the turbine
and if the collector unit is mounted correctly. Disengaging the functionality of the safety swit-
ches in any way is strictly prohibited.
• The engine must be disengaged immediately if the machine produces unfamiliar sounds. Exa-
mine the defect and perform any necessary repairs before continuing.
Warning:
Any suboptimal performance of the machine can compromise the operator’s
safety.
• While performing suction, the suction mouth must never be fully pressed to the ground.
Always allow for suction of sufficient air.
• Clotted leaves and humid materials may block the suction hose. Their suctioning must be
therefore be done with caution and step-by-step, not all at once.
• Should the hose get blocked nonetheless, one may attempt to loosen the lump by tapping on
the hose or moving it back and fro at the location of the blockage.
Emptying the collector unit.
• To empty the collector unit, release the latch at the front of the
collector unit.
Summary of Contents for CAMELEON M360
Page 1: ...CAMELEON M360 M450 M A N U A L ...
Page 36: ...36 Nederlands ...
Page 37: ...37 Nederlands 37 ...