80
English
the belt together in order to prevent damage, the ingress of dust or contamination and oil leaks.
• Unlock the lock located on the left hand-side thus allowing you to release the feed belt.
(2)
• Grip the two bent handles with both hands and pull the discharge belt conveyor upwards at an
angle in such a way that the hooks on either side unsnap from the shaft journals.
(3)
• Next, fold the belt down until it rests on the ground.
• Alternatively, lift the pivot point away from the machine to remove the discharge belt conveyor.
(4)
• To refi t the discharge belt conveyor, use a reverse sequence to that given for removal.
Caution:
Always be sure to lock the discharge belt conveyor. This is to make sure that the
discharge belt conveyor is kept pressed against a safety switch. In this way, the
safety switch cannot set off accidentally, which would otherwise switch off the
machine when shredding or moving.
Warning:
Never start the machine unless the discharge belt conveyor has been connected
to the hydraulic circuit. Failure to observe this prohibition may seriously damage
the components of the hydraulic system.
P3
Opening the shredding chamber
Warning:
Opening the shredding chamber gives you complete access to the blade system;
so always make sure to switch off the machine and to remove the key from the
ignition.
Caution:
The blades are razor sharp, avoid any contact with the blades and wear suitable
protective clothing (such as: heavy-duty gloves).
(2)
(3)
(4)
