Ligh-T
User Manual
All content is confidential. All rights reserved. 9
Precautions of Use
General Precautions
1.
Do not attempt to alter the Ligh-T or any components of the Ligh-T (tether, air module or
ground station). Any alteration of the product may cause severe damage and injury due to high
voltage electricity.
2.
Do not try to access the internal parts of the Ligh-T as it may damage its structural integrity and
cause an electrical hazard.
3.
Do not try to disconnect the tether from the Ligh-T. This operation can only be done by a
member of the Elistair maintenance team.
4.
Regularly inspect the Ligh-T with routine visual checks as described in the maintenance part of
this User Manual. If any defect is identified, do not use the Ligh-T and contact your dealer or
ELISTAIR customer service direct.
5.
Do not use the Ligh-T system below -10°C and over 40°C.
6.
Do not use the Ligh-T system under water.
7.
Please store the Ligh-T station in a dry location.
8.
Avoid exposing the Ligh-T to dust, humidity, heat and open flames.
9.
Use the Ligh-T with a power device integrated with a fuse rated to 16A.
Setup Precautions
10.
Verify that the maximum power consumption of the drone you want to connect is included in
your Ligh-T range of power.
11.
Ensure that the Air Module is securely fastened to your drone. This connection should be
manually checked by the operator.
12.
Make sure that the micro-tether is correctly connected to your drone.
a)
The mechanical connection should be attached to a robust part of the UAV airframe.
b)
The input and output power connections from the Air Module must be tightly fastened.
13.
For the safety battery, only use a 6S LiPo battery and carefully choose its capacity and discharge
rate to ensure at least two minutes of extra flight time at maximum power.
14.
Make sure the heatsink of the Ligh-T is not cover and the fan on the embedded power module
is clear of obstructions.
15.
Ensure the esc of the drone is without a regenerative breaking function or similar.
