Ligh-T
User Manual
All content is confidential. All rights reserved. 11
Alert name on app
Previous Condition
Alert
Alarm
Power consumption too
high
Always active
1600
2000
Cable cut or onboard
module failure, system
will shutdown, land your
drone
Power consumption was more than 200W
Power
consumption
under 200W
Power
consumption
under 200W
Temperature
of
the
system too high
Always active
55°C
65°C
If you encounter any problems you cannot resolve, contact your dealer or ELISTAIR customer service.
Setup
Pre-Flight Check List
Ensure that all parts of the Ligh-T are in a good condition before each flight. Do not fly with broken or
damaged parts. Before using the Ligh-T, always use the checklist below.
1-
Make sure that the Ligh-T station is not damaged in any way.
2-
Verify that the maximum power consumption of the drone you want to connect is included in
the Ligh-T range of power.
3-
Check the status of the safety battery and make sure it is fully charged (above 95%).
4-
Ensure that the safety battery you chose is at the right voltage (6S) and in good condition.
5-
An external power supply source is needed. When using a generator, check the fuel level and
that you are using a pure sinewave inverter.
Start-Up Instructions
Before take-off, always use the start-up instructions below to verify the setup.
1-
Ensure that the surrounding area is clear of obstructions.
2-
Connect the power supply unit or the main power supply to the Ligh-T ground station.
3-
Make sure that the Air Module is securely attached and correctly connected to your drone
(power connector and Ethernet connector).
4-
Check the integrity of the micro-
tether’s
first five meters.
5-
Connect the mechanical fastener (at the end of the micro-tether) to your drone airframe.
6-
Connect the micro-tether power connector to the Air Module. Screw it until mechanical stop.
7-
Be sure that the micro-
tether isn’t in the way of the
propellers.
8-
Connect the data connector at the end of the micro-tether, to the data input connector on the
Air Module.
9-
Verify that the micro-tether is not en
tangled with the drone’s feet,
to avoid drone imbalance.
10-
Plug-in the emergency battery to the Air Module. Air Module should now turn-on and
supply the drone.
11-
Turn on the micro-tether power supply.
12-
Check on the T-monitor app, the power consumption should be greater than 200W when you
are flying.
Your drone is ready for take-off.
