Attaching Fix Plates
Make sure that the material and frame are both laying face down on a clean, dry and
non-abrasive surface. Center the material inside the frame. It will be noticeably smaller
because stretching the material is required to create a sufficient amount of tension for perfect
material flatness. Start in the center of the long horizontal edge and then alternate with the
short sides as shown in the diagram (fig.6). Numbers 1-8 indicate the recommended order that
you should attach your fix plates per section for an even tension distribution.
FINAL ASSEMBLY AND INSTALLATION
Insert the Center Support Bar into
the groove on the back of the frame
with the bottom end near the
approximate center of the frame.
Place it in at an angle so that both
ends of the bar are in alignment with
the groove. Slide the top end of the
bar into place forming right angles
to the top and bottom of the frame.
This will provide added stability to
your frame and added tension to the
material.
Center Support
Center Support