Operating the Kestrel Series Screen
Setup:
Remove the controls and wiring from the compartment on the left side of the
Kestrel
Floor Electric Screen as shown in the pictures below.
Connect the screen to the power supply a n d s w i t c h t h e p o w e r b u t t o n o n . N o w i t i s r e a d y
f o r u s e .
Power:
ON OFF
About the Control System:
1. 5-12V Trigger Input:
The built-in 5-12V trigger input for your new Elite
Kestrel
allows your
screen to synchronize its rise and drop with the projectors power cycle. The screen rises when the
projector powers up and retracts when the projector powers down.
2. IR (Infrared) and RF (Radio Frequency):
The Kestrel Series screen includes both IR and RF
receivers that enable the consumer to use either the IR remote control with direct line of sight
through the screen’s IR receiver window. The RF remote is best used when the screen is
concealed or long distance control is required. The RF technology therefore
does not
require line
of sight directly to the screen’s IR receiver window.
IR receiver window
www.elitescreens.com
Page
5
of
8
