Updated 05/25/17
2
www.elitescreens.com
Adjustment instructions are as follows:
If the screen is not retracting fully in to the housing: Insert the Allen wrench in to the upper limit
screw and turn it counterclockwise
. The screen will rise as you turn the Allen screw.
If the screen doesn’t stop retracting once it reaches the top: Insert the Allen wrench in to the top limit
screw and turn it clockwise about 10 full times at a time. Note: the screen does not react when
making this adjustment. You will need to test the rise by lowering the screen a third of the way and
then retracting it back up
. Repeat this step until the motor automatically shuts off when rising.
Upper limit adjustment screw.
Lower limit adjustment hole to
access the lower limit screw.
