4
ELT-KLCD EliteSuite Installation Manual
The following diagrams show each of the zone wiring configuration
settings that are possible. The programmed zone configuration for
the EliteSuite LCD Keypad is made in the option settings. Refer to the
General Options Section on Page 16 for the programming of the zone
configuration.
When using a tamper input on a device the tamper contacts
must be normally closed and wired in series.
All resistors required to wire the zone configurations are
provided with the EliteSuite LCD Keypad in the accessory bag.
Figure 4 - 2 Zone Input (No Resistors)
Figure 5 - 2 Zone Input (1K and 1K)
