Page 37 of 130
DOC No.
：
T202001006
DANGER:
1. Make sure that all equipments which must be kept far away from
water are kept dry. If the water enters into the product, please turn off
the power supply and then contact with your provider for assistance.
2. Only use the original cables supplied with the robot. Do not use
the robot in applications where the cables are subjected to flexing. If
a longer cable or a flexible cable is needed, contact your provider.
3. A negative connector is defined as the Ground (GND) connector
which is connected to a shield of the robot and the control box. All
GND connectors mentioned in the text are only suitable for powering
and transmitting signals. For protective earth (PE), please provide
the control box with the reliable GND with the dedicated power
supply socket of the control box.
4. Please be careful when installing the interface cable to the robot
I/O. A metal plate on the back of the box is intended for the interface
cables and connectors. Please remove the metal plate before drilling
holes. Make sure that all matte sides are removed before reinstalling
the metal plate. Remember to use the correct size gland.
Caution:
1. The robot has been tested in accordance with international IEC
standards for electromagnetic compatibility (EMC). Disturbing
signals with levels higher than those defined in the IEC standards
may cause unexpected behaviors of the robot. Very high signal level
or excessive exposure may damage the robot permanently. The EMC
problems happen usually during welding and are usually prompted
by the error messages in the log. ELITE shall not be held responsible
for any damages caused by EMC problem.
