Page 88 of 130
DOC No.
：
T202001006
After performing a copy operation or a cut operation, move the cursor to the line
immediately before the desired position in the program editing page. Press [PASTE] to complete
the paste operation. Note that the instruction lines are inserted in the next line of the cursor line.
Deleting
There are two types of delete operations: [LINE DELETE] and [BLOCK DELETE]. [LINE
DELETE] only deletes the instruction line selected by the cursor (Note that the NOP and END
lines cannot be deleted). Press [BLOCK DELETE], and the dialog box will pop up for specifying
the range of the instruction lines to be deleted. Press [OK] to complete the delete operation.
Searching
Press [SEARCH] and the search window will pop up. The items can be searched are the
additional items of each instruction. Note that the items displayed for each instruction in the
normal instruction mode and advanced instruction mode are different. Select the item to search,
and input the corresponding value. Then press [SEARCH] in the submenu area to find the
instruction line that meets the requirements in the current program. The cursor will move to the
line automatically.
