9MA10011
32/52
6.6 Printer Errors
At the start of or during a print job, a number of problems may occur with the
printer. These have been listed in the table below:
Message
CAUSE
EFFECTS
REMEDY
N.B.
No data to
No print
Printer LED
blinking
Out of paper
No print
Replace paper roll
Printer LED
blinking
Printer not
connected
No print
LED
permanently
on
Printer LED
permanently
on
Printer error
No print
Printer LED
permanently
on
Print job
suspended
manually
suspended
Take out the paper
roll and repeat the
print procedure.
7. DOWNLOAD DATA WITH SD CARD
The new version of the Memory 1000 has a new fast data download function
via SD CARD.
NOTE: The SD CARD must be at least 2GB and be previously formatted
with FAT12, FAT16 or FAT32.
Enter the SD CARD in the slot (see Fig. 1), Memory 1000 will recognize it
automatically and the words “
SD CARD In
” will appear on the display.
Once the controller has recognized it and checked it has been formatted, it will
immediately start to download data. Data will be downloaded to this folder:
\\MMDATA\xxxxxxxx\BIN
where “xxxxxxxx” is a unique 8-figure code identifying the Memory 1000.
During downloading, ‘
Downloading Data
’ appears on the display.
Once downloading is complete, ‘
SD CARD Out
’ appears on the display.
At this point, the SD CARD can be removed and read by a PC.
The data downloaded can be imported by the same software used for downloading
via the serial port on the controller.
NOTES:
1) The MMDATA directory will be created automatically if it does not
already exist.
2) Data will be grouped into 64k byte files with a sequential number
identifying the chronological order in which they were saved.
3) Never try to remove the SD CARD when data is downloading as this
could corrupt the data or damage the CARD.
fig.1
Summary of Contents for Memory 1000
Page 1: ...English Memory 1000 Multichannel data logger 9MA10011...
Page 2: ...9MA10011 2 52...
Page 4: ...9MA10011 4 52...
