M1 Cross Platform Controllers - User Guide
Page 16
5-KEYPAD TEMPERATURE SENSORS
Provides the ability to select and
view the temperature sensor inside a M1KP LCD keypad. Note: M1KP2 LCD
keypads do not have an inside temperature sensor. If you select a keypad
that happens to be an M1KP2 the display will read “Not Enabled”. Press the
RIGHT arrow key to select this menu, then press the UP or DOWN arrow keys
to scroll through the list of available keypads. To jump directly to a particular
keypad enter it’s two digit number. The current temperature at the keypad will
display. Press the * key to exit.
6-THERMOSTATS
If HVAC thermostats are connected their current tempera-
ture may be read from this menu. Press the RIGHT arrow key to select this
menu, then press the UP or DOWN arrow keys to scroll through the list of
available thermostats. To jump directly to a particular thermostat enter it’s two
digit number. The current temperature is displayed. Press the * key to exit.
NOTE: To reduce scroll time, the keypad only displays the entities:
Tasks, Lights, Outputs, Temperature Sensors, Keypads, and Thermo-
stats which are installed, programmed, and selected to “show” on the
keypad. This is done by the installer and can be changed as new
equipment is added. It is also possible to enter a 2 or 3 digit number
and jump to ANY entity, even those NOT selected to “show”.
Menu 2-Reset Smoke Detectors
This is used to reset latched smoke detectors following a Fire alarm trip.
When a Smoke Detector causes an alarm it’s output circuitry will latch ON to
provide a visual identification. IMPORTANT: It will be necessary to reset the
smoke detector circuitry following an alarm in order for any subsequent Fire
alarms to be detected.
1. Press the ELK key. Enter a user code if prompted.
2. Use the UP or DOWN arrow keys to find “2-Reset Smoke Detectors”.
3. Press the RIGHT arrow key to select this menu.
4. The keypad will display “5 Seconds Smoke Output Reset”.
5. Two beeps from the keypad indicates that the reset is complete.
The keypad will automatically return to the main display.
