M1 Cross Platform Controllers - User Guide
Page 18
Menu 5-View (Zone) Status
This allows a comprehensive viewing of the status for all area zones
1. Press the ELK key. Enter a user code if prompted.
2. Use the UP or DOWN arrow keys to find “Menu 5-View Status”.
3. Press the RIGHT arrow key to select this menu.
4. The first zone is displayed with it’s current status and name. Press
the UP arrow key for the next zone or press the DOWN arrow key for
the previous zone. To jump directly to a particular zone enter it’s
three digit number.. I.E.: To jump to zone 16 enter “016”.
5. When done, press the * key to exit back to the menu selections.
Menu 6-Change User Codes
A Master Level User Code is required to change User Codes.
1. Press the ELK key. You must enter a Master Level User Code.
2. Press the UP arrow key to find: Menu 6-Change User Codes.
3. Press the RIGHT arrow key to select this menu and use the UP
arrow to locate a user OR enter 3 digits to jump to a specific user.
5. The keypad will display:
001:Sel Chg
{name of User}
6. To change the code press the RIGHT arrow and enter the new code
digits. Codes are either 4 or 6 digits in length, depending on how
the installer set up the programming. Refer to the System Notes.
7. If the code is accepted the keypad beeps 3 times. If a long error
tone is heard the keypad will display: “Code Not Authorized”. Press
the RIGHT arrow to “Redo” and repeat step 6 using different digits.
8. To change or edit a name press the RIGHT arrow key followed by
the DOWN arrow key. The cursor starts in the lower left corner.
Select each letter using number keys 1 thru 9. E.G.: Each press of
the 5 key will produce: J, then K, then L, and then 5. To move to the
next letter press the RIGHT arrow. For a space press the Chime
key. To delete a character press the Bypass key. For upper case
press the UP arrow then select a letter. For lower case press the
DOWN arrow. When finished, press ELK key to save the name.
9. To back up to another user or to select another menu press the ELK
key until the correct display is shown.
10. To exit all the way back to the main display press the * key.
