M1 Cross Platform Controllers - User Guide
Page 21
Operation Via Telephone
The system may be optionally controlled from a Telephone using push-button
“tone” commands. Consult the installer to determine if this option is available.
If available, the control may be operated from an inside telephone, an outside
telephone, or both. Both methods will be discussed in detail below.
Operation from an Inside Telephone:
1. Lift the telephone and listen for dial tone.
2. Press * * * to alert the control. The control will pick, disconnect the
phone line and dial tone, and announce: “Please enter security code”.
3. Enter a valid user code. If code is correct the control should
announce: “Access Authorized”.
4. Enter a menu selection OR press 0 to hear the entire menu.
Operating from an Outside Telephone:
1. Dial-in to the phone number attached to the control. After a
programmed number of rings the control should answer with four
short beeps. If an answering machine picks up, wait for the message
to quit and proceed as follows:
2. Press * * * to alert the control. The control will announce: “Please
enter security code”.
3. Enter a valid user code. If code is correct the control should pickup
announce: “Access Authorized”.
4. Enter a menu selection OR press 0 to hear the entire menu.
Menu Selections:
Main menu options are underlined.
For Help press 0
. A voice message explains the function of each key.
For Arm Status press 1
. Allows the system to be armed or disarmed.
Voice messages will prompt you through the entire process.
For Automation Control press 2
. Certain features of the system or pre-
mises may be controlled from this menu such as: Turning on a light, a pump,
a sprinkler system, etc. Consult your installer. Follow the detailed prompts.
For Trouble Status press 3.
If there are any system troubles such as low
battery, AC power loss, etc., they will be announced. Follow the prompts.
NOTE: This feature not avaliable with the M1EZ8
