M1KPNAV Navigator Touchscreen Keypad - User Guide
Page 5
View Violated Zones
To view zones that are violated (not ready) press the button labeled “Violated
Zones” on the top right corner of the button arrangement. The display will
begin with the first violated zone. The Up and Down buttons that appear in
the Status Window can be used to move between zones.
The Main Screen contains a numeric entry keypad along with several
feature buttons, some of which are not found on other Elk M1 Keypads.
EXIT - Arming in the “Away” Mode
Away mode arming is the highest arm level, intended for use when the
premises is unoccupied. Both perimeter and interior zones will be armed.
The
Ready
to Arm or Ready to Force Arm must be present for the alarm to
be armed.
1.
Enter a User code or press Exit (Quick Arm must enable by Installer).
2.
Display will change to Armed Away.
The exit tone will begin to countdown.
4.
Leave the premises immediately while the exit delay is active.
5.
At the end of the exit delay the system will be fully armed Away.
During the final 10 seconds of the exit delay the exit tone will beep faster,
warning that time is nearly expired. If you feel that you will NOT be able to get
out and close the exit door within the remaining time it is recommended that
you start over by returning to the keypad, disarm the system, and arm again.
EXIT - Arming in the “Vacation” Mode
Vacation mode is a second level of Away mode and is primarily useful to
activate energy saving automation features when the building is not occu-
pied for an extended time. After arming, press the EXIT button again to
change the armed mode to vacation.
