© 14.11.2005 ELKA-Torantriebe GmbH u. Co. Betriebs KG Page 12 TERRA 180/182 - 250/252 – 320/322
The welding profile can be used as drilling template.
Connect the gate support with the provided screws to the gate wing. The emergency
release is located in the gate support. Use the enclosed key to release the emergency
release lock and push the lever down. The nosing moves into the gate support. There is a
50mm
∅
drilling hole in the bottom of the gate support. Now place the gate into the upper
hinge. Place the gate with the gate support onto the gearbox shaft, which protrudes from
the underfloor opener. Push the lever up and lock the emergency release with the key (see
drawing 7).
Drawing 9
Move the gate until the nosing of the emergency release engages into the driver plate by
itself. Now the gate opener and the gate wing are connected again.
4.3. Checking of the movement
Release the gate opener manually again. Check, if the gate can be moved easily by hand
between OPEN and CLOSED. Engage the release in any chosen gate position. When the
gate is moved again, the nosing engages automatically (original installation position). Now
the gate opener and the gate wing are connected again.
