© 14.11.2005 ELKA-Torantriebe GmbH u. Co. Betriebs KG Page 15 TERRA 180/182 - 250/252 – 320/322
n. Replace the pinion and make sure that the marks on pinion and gear shaft correspond.
o. Replace the plug to the 5-pin connection
FAHR
.
Attention: The gate moves automatically during the next installation step.
p. Next the controller learns the running distance of the gate wing. Push the button
LERN
.
The controller moves the gate wing into direction OPEN until the end stop and then into
direction CLOSED until the end stop (display P2).
The gate is now in position CLOSED. Should the gate now be in position OPEN, the
wires 4 and 5 of the motor connection cable at the 5-pin connection have to be
switched. Then repeat step p) by pressing button BTG once (display
P1
) and
pressing button LERN three times (display
1F
,
HA a
nd
AU
).
q. Push button BT until
PP is displayed
. Confirm with button LERN.
In case it is necessary to change the position of the internal stops (changing
of the gate, exchanging of the motor etc.), see paragraph 4.7. – Re-adjusting
of internal stops.
r. Continue with paragraph 4.5.
For additional options for adjusting of the controller see paragraph 8.1.
