Elka TERRA 180, Installation And Operating Instructions Manual

© 14.11.2005 ELKA-Torantriebe GmbH u. Co. Betriebs KG              Page 28                                  TERRA 180/182 - 250/252 – 320/322 

8.1.5. Sequence P5: Learning and deleting of code for radio 

remote control for BT, BTG and MULTI 

To learn a code the transmitter has to be operated. The code will then be stored. When 
sequence 

P5 

is activated with the button 

LERN

, an additional selection menu is displayed 

for selecting the code. Move to the next point using button 

BT.

Sub-sequence Function 

C1 

Radio remote control code for BT can be learned or deleted 

C2 

Radio remote control code for BTG can be learned or deleted 

C3 

Radio remote control code for MULTI can be learned or deleted 

Next 

Return to main sequence 

Table 13 

Sub-sequence is activated with button LERN. The display shows: 
 

Display Corresponds 

to: 

- - 

The selected radio remote control code is deleted and another can be learned. 

oo 

The selected radio remote control code is already stored and can be overwritten 
or deleted 

Table 14 

To erase the radio remote control code, press and hold the button 

BT 

and additionally 

push the button 

LERN.

 The radio remote control code is erased. Return to the sub 

sequence follows automatically. If only the button 

LERN

 is pushed, then return to the sub 

sequence follows immediately without erasing the code. 

 
Radio remote control signal: 

Receiving of a learned radio remote control signal is displayed through lighting of the right display dot.

 
8.1.6. Sequence P6: Automatic closure for complete opening 

 
When sequence 

P6 

is activated by button 

LERN

, the present value for stay-open time for 

complete opening is displayed. Possible values are 

-- 

(not activated), 

01

 up to 

299 

(for 1s - 

299s). The value can be increased using button 

BT 

and decreased using button 

BTG.

The decimal dots of the display are each equal to 100 (one lit dot = 100 /  
two lit dots = 200). 
 

Display (example)  Corresponds to: 

- - 

Automatic closure is deactivated. 

23 

Automatic closure is activated. Stay-open time 23 seconds. 

23. 

Automatic closure is activated. Stay-open time 123 seconds. 

2.3. 

Automatic closure is activated. Stay-open time 223 seconds. 

Table 15 

 
Return to the learning sequence using button 

LERN

. 

 
When using automatic closure both wings close automatically after the learned stay-open 
time has elapsed. The stay-open time starts elapsing when the last wing has reached the 
position OPEN. 
 

-  When contact BS is opened, the automatic closure function is blocked. 
-  When the stay-open time has elapsed and the safety contact profile for direction 

CLOSE (SLZ) is currently activated, the gate remains open. The elapsed stay-open 
time will not be repeated. When the SLZ is not activated anymore and the stay-
open time has elapsed, the warning time prior to closing starts.