© 14.11.2005 ELKA-Torantriebe GmbH u. Co. Betriebs KG Page 34 TERRA 180/182 - 250/252 – 320/322
8.1.12. Sequence PC: Pressure relief of electromechanical bolt
When sequence
PC
is activated by button
LERN
, the present selection is displayed. With
the button
BT
the value can be selected (see table).
Return to the learning sequence using button
LERN.
Display Corresponds
to:
S1
Pressure relief for electromagnetic bolt is deactivated.
S2
The gate wing pushes slowly (500ms min., but 1000ms max.) against the end
stopper until the selected force is reached.
S3
The gate wing pushes slowly (500ms min., but 2000ms max.) against the end
stopper until the selected force is reached.
S4
The gate wing pushes slowly (500ms min., but 90s max.) against the end stopper
until the selected force is reached.
Table 21
INFORMATION: For operational safety it is necessary to
set the pressure relief for electromagnetic bolt on S2
.
8.1.13. Sequence PD: Wind blast suppression
It can be chosen to either reverse on obstacle immediately, or to reverse after a preset
time. When setting a time, a short wind blast or an oscillating gate wing do not result in a
stop (and reversal).
Warning: Only use the wind blast suppression, when additional safety
devices like photo-cells and safety contact profiles are installed at the gate.
When sequence
PD
is activated by button
LERN
, the present selection is displayed. With
the button
BT
the value can be selected (see table).
Return to the learning sequence using button
LERN.
Display Corresponds
to:
U -
No wind blast suppression. The controller immediately reacts on obstacle/wind
blast.
U1 - U9
The wind blast suppression equals 1s (for U1) up to 9s (for U9). The controller
reacts on obstacle / wind blast only after the selected time 1s (for U1) up to 9s
(for U9).
Table 22
8.1.14. Sequence PE: Multi-functional relay
The multi-functional relay on the controller is suitable for four different modes. During
learning function the relay is inactive.
When sequence
PE
is activated by button
LERN
, the present selection is displayed. With
the button
BT
the value can be selected (see table).
Return to the learning sequence using button
LERN.
Display Corresponds
to:
r1
Push button mode: The relay is active as long as the controller receives the radio
remote control code MULTI.
r2
Toggle mode: The relay alternates between active and deactive with each radio
remote control code MULTI.
r3
Light pulse mode: The relay is active for 1 second, when BT, Funk BT, BTG,
Funk BTG, BA or BZ are pushed.
r4
3-minute light: The relay is active for 180 seconds, when BT, Funk BT, BTG,
Funk BTG, BA or BZ are pushed.
Table 23
