Elkay GreenSpec LVRC8WS, Installation And Use Manual

Page 6

98980C  (REV. K- 08/17)

LVRCDWS*A, *2A   LVRCTLDDWSC*A, *2A   LVRC8WS*1A, *2A, *3A   LVRCTL8WSC*1A, *2A, *3A

STANDARD TWO-LEVEL CONFIGURATION

1/4” HEX. HEAD BOLT THIS LOCATION ONLY

REMOVAL OF BOTTLE  FILLER FOR SERVICING

1)   

Turn off the water supply

 to the Water Cooler(s). Unplug and/or turn off Circuit Breaker to Cooler(s) and Bottle Filler. 

NOTE: 

the Lower Front Panel  

      of the cooler(s) may need to be removed. To prevent scratching the basin place a towel or soft cloth over the entire basin when working above it.

2)   

For Single Model Installations:

 Loosen but DO NOT remove the two (2) Pinned Torx Head Screws from the sides of the Bottle Filler. Remove the 

      two (2) Pinned Torx Head Screws from the Top Cover & remove the Top Cover.  The Bottle Filler may then be lifted up and off the Water Cooler 

      (The water line and Remote Reset Button Wires will still be connected from the Water Cooler to the Bottle Filler.). 

3) 

 For Two Level Model Installations: 

Loosen but DO NOT remove the Pinned Torx Head Screw from the outer side of the Bottle Filler and loosen but DO NOT remove 

the 1/4” hex. head bolt from between the two cooler (See Figs 6 or 7). Remove the two (2) Pinned Torx Head Screws from the Top Cover & remove the Top Cover.  

The Bottle Filler may then be lifted up and off the Water Cooler (The water line and Remote Reset Button Wires will still be connected from the Water Cooler to the 

Bottle Filler.)

Fig. 6