5
6
1
2
3
4
RFWB-40/G
RFWB-20/G
On-wall button controller
RFWB-20/G, RFWB-40/G
Characteristics
• The wireless controller is used to control switches and dimmers (lights, gate, garage door, blinds, etc.).
• RFWB-20/G:
two buttons enable control one or two units independently (depending on the type of swit-
ching element).
• RFWB-40/G:
four buttons enable control from two up to four units independently (depending on the type
of switching element).
• The flat design with level base makes it ideal for fast installation on any surface (fixation with adhesive or
screws in the installation box).
RFWB-20/G –
On-wall button controller PLASTIC - 2 buttons
RFWB-40/G –
On-wall button controller PLASTIC - 4 buttons
Safe handling
Battery replacement RFWB-20/RFWB-40
Using a screwdriver,
carefully pry off
the device from the
frame.
Gently pull to
remove the cover.
Slide the CR2032
battery into the
battery holder.
Observe the
polarity.
Snap on the cover.
The LED opening
must be located
in the upper part
(for the RFWB-
40, observe the
positioning of the
left and right cover
Place the frame
on the rear part.
Snap the device
with the cover
into the prepared
frame.
When handling a device unboxed it is important to avoid contact with liquids. Never place the device
on the conductive pads or objects, avoid unnecessary contact with the components of the device.
Detailed manual