8/12
INSTALLATION
A
A
A
A
A
Clip for
front panel
opening
Clip for
front panel
opening
Hole for
wires
Hole for
wires
Clip for
front panel
opening
Clip for
front panel
opening
Hole for
wires
Fasten
hole
Fasten
hole
Hole for
wires
Fasten
hole
Fasten
hole
Rear view
Fix the addressable device by following the instructions reported below:
Remove the cover from the device by acting on the clips.
In the wires access used M20 Cable/Tube Gland.
Install on a wall by using the relevant fixing holes placed on the bottom of the enclosure (as
illustrated in the picture).
Connect the device TM24I according to the schematic illustrated in the picture.
Important: connect the end of line resistor, used for supervising the connection between the
control panel and type “C” fire alarm devices, to the OUT terminal block of the last device
connected to the fire alarm signalling circuit. The value of the end of line resistor is indicated in
the documentation of the fire detection control panel.
Insert the 2 provided rubber blocks, as illustrated in the picture, on the retention hooks with lower
protrusion; close the cover to the device by observing the alignment arrows
.
Secure the cover with the provided screws.
Apply the supplied stickers on the four clips for front panel opening and the side hole for wires,
indicated with “A”.
How to replace the pictographs into the device:
Remove the cover from the device by acting on the clips;
Remove the transparent part from the cover by acting on the clips;
Insert the desired pictograph between the transparent part and
the cover;
Re-assemble the transparent part on the cover and insert the 2
provided rubber blocks, as illustrated in the picture, on the
retention hooks with lower protrusion; close the cover to the
device by observing the alignment arrows
.
Secure the cover with the provided screws.
