2.
N4FS03
1X
-
Loosen the screw in the bottom of the vertical profile,
remove the bottom bracket.
- Cut the soft edge of the seal N4FS03 by 3"(75mm) on one end.
- Insert the seal into the bottom aluminum frame.
- Tie off the end of the seal keep it from moving.
- Put the bottom cap on the vertical profile, fix it with screw.
4
3.
1X
N4FS01
- Put the wall profile(N4FS01) against the wall and
ensure it is vertical using a spirit level.
- Recommended gap between profile and bath edge
is between 10-15mm.
- Mark the holes on the wall.
10-
15m
m
Note
: Please observe cut required.
3"(75mm)
N4FS02
