Air Button Operating Instructions
Single Speed Pump (
Water
):
The Whirlpool Water
System is activated by pressing the Water Button.
Ensure first that there is sufficient water in the Tub to at
least cover the Jets. (If not, the Water Detection
Function will prevent the Pump from starting dry). This
will turn on the Pump, and activate its 20-minute timer. The
Whirlpool Water System will stop automatically when its timer
expires. To turn off this function earlier, press the Water System
Button at any time.
Variable-Speed Air Blower (Air):
The Air system is
activated by pressing the Air Button.(The Air System
runs independantly of the Tub Water Level).This will
turn on the Blower, and activate its 20-minute timer.To
change the Speed of the Blower, press and hold to start
the Blower, and then ramp its Speed down. Release at the
desired setting.To activate the "Massage Mode", press and hold
to start the Blower, and then ramp its Speed down to the lowest
setting, pause, then release.To turn off the Air System earlier,
press the Air Button at any time.
Automatic Dry Cycle:
15 minutes after the Water and/or Air
systems are turned off, or the tub is drained, the Air Blower will
automatically come on for 2 minutes. This will purge out any
residual moisture in the air system, making the system fresh and
ready for the next bath.
Multi-color Tub Light (
Light
)
The LED Multi-Color Tub Light is activated by pressing
the Light Button. The first press will start its 60-minute
timer, and activate the Tub Light in a
“
Rainbow
”
mode.
Subsequent presses will change the color to Blue,
White, Blue, Aqua, Green, Yellow, Red, Magenta, and
off. To turn off this function earlier, press and hold the Light
Button at any time.
Light
Air
Water
May not be applicable to your specific package
Refer to your package diagrams for more information
25 of 38
