- 3 -
y
If the product does not operate normally by following the instruction manual,
only adjust the controls that are covered by the operating instructions. An
improper adjustment of other controls may result in damage and will often
require extensive work by a qualified technician to restore the product to its
normal operation.
y
If the product has been dropped or damaged in anyway.
y
When the product exhibits a distinct change in performance this indicates a
need for service.
15.
If replacement parts are required, be sure the service technician has used the
replacement parts specified by the manufacturer, or that the replacement part has
the same characteristics as the original part. Unauthorised substitutions may result
in fire, electric shock, or other hazards.
16.
Upon completion of any service or repair to this product, please ask the service
technician to perform safety checks to determine that the product is in proper
operating condition.
17.
The product should be situated away from heat sources such as radiators, gas heater
or open fires, electric heaters, stoves, or other electrical products including
amplifiers that produce heat.
Note:
This device has been tested and found to comply with the limits for a class B
digital device, pursuant to the FCC Rules, or BZT, CE EMC and C Tick directive. These
limits are designed to provide reasonable protection against harmful interference in a
residential installation. If not installed and used in accordance with the instruction, it
may cause interference to RF communications. However, there is no guarantee that
interference will not occur in a particular installation. If this device does cause
interference to RF or television reception, which can be determined by turning the
device off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Increase the separation between the device and other equipment.
Connect the device into a power outlet on a circuit different from that to which the
other equipment is connected.
Use good quality, shielded coaxial cable and try to avoid sharp bends.
Consult the dealer or an experienced RF/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user authority to operate the
equipment.
