page 4
5. Fan Assembly.
set screw hole
set screw
hanging ball
stop pin
A
B
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the 8in.
downrod provided to use with an extended downrod
(sold separately). [
If you wish to use the 8in. downrod,
please proceed to instructions following the dotted line
below.
]
To remove hanging ball, loosen set screw on hanging
ball, lower hanging ball and remove stop pin. Slide
hanging ball off the original downrod, A, and slide it
down the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball. Be
sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
Tip
: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the
downrod.
Locate canopy cover in hardware pack. Loosen yoke
set screws and nuts in yoke at top of motor and
remove pin and clip from yoke at top of motor. Slide
downrod through canopy, canopy cover and yoke
cover. [
Note
: Canopy cover must be turned with shiny
side
toward
the motor.]
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper
end of the downrod.
Place downrod into the yoke at top of motor and re-
insert pin and clip. Securely tighten yoke set screws
and nuts. Lower yoke cover onto the top of the
motor.
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
canopy cover
downrod
yoke cover
canopy
pin
clip
motor
electrical wiring
yoke set screw
safety cable
