page 7
9. Blade Assembly.
10. Light Kit Assembly (Optional).
motor housing
blade arm
blade
light kit
fitter
If you wish to use your fan WITHOUT a light kit:
Remove 3 screws from switch housing cap. Be
sure that wire connectors are secure and then
tape each wire connector separately with
electrical tape. Align holes in switch housing cap
with holes in switch housing. Use screws that
were just removed to attach switch housing cap
to switch housing.
Please proceed to Section 11 on
the following page to complete installation
without
light kit.
If you wish to use your fan WITH a light kit:
Remove 3 screws from light kit fitter.
Note:
This fan is equipped with a wattage limiting
device. Therefore, using a light kit other than the
one provided may cause the light kit to fail.
Locate
BLACK
and
WHITE
wires in the switch
housing labeled FOR LIGHT. Remove and discard
cardboard label and plastic that hold these 2 wires
together.
Remove wire connectors from the same 2
wires as well--save wire connectors for later use.
Next, locate
WHITE
and
BLACK
wires in light kit
fitter labeled FOR LIGHT KIT CONNECTION.
["Light Kit Assembly" continued on next
page.].
blade attachment
screws and washers
blade arm screws
lock washers
motor housing
switch housing cap
switch
housing
black wire
white wire
black wire
white wire
Time Saver:
Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in one of the hardware packs. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat for the
remaining blades.
Remove blade arm screws and lock washers from
fan motor and set aside. Then, if applicable,
remove plastic motor blocks from underside of
motor and discard plastic motor blocks
(save
blade arm screws and lock washers to secure blade
arms)
. Align blade arm holes with motor screw
holes and attach blade arm with screws and lock
washers. Before securing screws permanently,
repeat this procedure with remaining blade
arms. Secure all screws.
Note
: Tighten blade arm screws twice a year.
plastic
motor
block
