page 7
light
kit fitter
fitter plate
glass shade
9. Light Kit Assembly.
molex
connections
Remove 1 screw from the fitter plate on the
underside of the motor and partially loosen the
other 2 screws. Align the slotted holes in the
shade fitter with the loosened screws in the
fitter plate, making sure that molex connections
come through the hole in the middle of the
shade fitter. Twist shade fitter to lock. Re-insert
the screw that was previously removed. Tighten
all screws securely.
Remove 1 screw from the shade fitter and
partially loosen the other 2 screws.
Connect
WHITE
wire from light kit fitter to
WHITE
wire from motor housing. Connect
BLACK
wire from light kit fitter to
BLACK
(or
BLUE
) wire from motor housing. Be sure that the
molex connections snap together completely.
Gently arrange the wires within the light kit
fitter and then align the slotted holes in the
light kit fitter with the loosened screws in the
shade fitter. Twist the light kit fitter to lock.
Re-insert the screw that was previously
removed. Tighten all screws securely.
Install the 100 watt mini can halogen bulb
(included).
Tip
:
Do not touch glass portion of bulb with
fingers or hands. Oil from skin can cause bulb to
overheat and go out prematurely. Use cardboard
box or foam wrapping bulb was packed with to
layer around glass portion of bulb.
Locate slots on glass shade and align with
dimples on shade fitter. Push up gently on glass
shade. Turn glass shade in a
clockwise
direction
until it slides completely into place.
IMPORTANT
:
The glass shade must be removed
in order to replace the bulb. When you need to
replace the bulb, please allow bulb and glass
shade to cool down before touching. Use one
100-watt
max.
halogen bulb, type JD E11, to
replace the bulb, keeping in mind not to touch
the bulb itself as described above (see "
Tip
").
shade
fitter
plate
motor
housing
bulb
